Get This Free Cheat Sheet Guaranteed To Help Your Next Mix

Wednesday, February 3, 2016

Mastering Compressor Tips And Tricks

Mastering Compressor Tips imageWith powerful mastering tools now available to everyone, it's easy to do more harm than good when self-mastering. Although you're always better off going to a true mastering engineer, sometimes that's just not in the budget.

Here are a few mastering compressor tips from my book Mixing And Mastering With T-RackS: The Official Guide that I don't think you'll find anywhere else.

"Adjusting the Attack and Release controls on the compressor and/or limiter can have a surprising effect on the program sound.
  • Slower Release settings will usually make the gain changes less audible but will also lower the perceived volume. 
  • A slow Attack setting will tend to ignore drums and other fast signals but will still react to the vocals and bass.
  • A slow Attack setting might also allow a transient to overload the next plug-in or piece of equipment in the chain.
  • Gain changes on the compressor caused by the drum hits can pull down the level of the vocals and bass and cause overall volume changes in the program. 
  • Usually only the fastest Attack and Release settings can make the sound “pump.” 
  • The more bouncy the level meter, the more likely that the compression will be audible.
  • Quiet passages that are too loud and noisy are usually a giveaway that you are seriously over-compressing."


1 comment:

Anonymous said...

IMO "self-mastering" is merely another step in the mixing process. Until you hand it off to an unbiased, objective third party mastering engineer you are still mixing.

LinkWithin

Related Posts Plugin for WordPress, Blogger...